Lawson Canned Reports? EEO - 1 PA390
Last Post 08/05/2011 1:19 PM by TRACY. 3 Replies.
Printer Friendly
  •  
  •  
  •  
  •  
  •  
Sort:
PrevPrev NextNext
You are not authorized to post a reply.
Author Messages
TRACY
Private
Private
Veteran Member
(130 points)
Veteran Member
Posts:58


Send Message:

--
08/02/2011 11:27 AM
    We want to validate the numbers in PA390. Is there a report in Lawson that will show us a list of all employees that are currently under Category 20 for instance? We have already ran the report for this year and when the report says there are 394 white, category 20 employees we want to know the names of these 394 employees. This is just an example. Thanks so much for your help. I believe in Portal last year I stumbled across a way to use Drill around and then print the employees, but of course it has been a year and I did not document well, so if anyone has any ideas about this too, that would be helpful.
    MichelleW
    Private
    Private
    Basic Member
    (42 points)
    Basic Member
    Posts:20


    Send Message:

    --
    08/03/2011 7:33 AM
    You could always build a report in HR Writer to capture the employees in a certain EEO Cat. or you could build an employee group and use the pa335 to generate your listing.
    If you use Crystal Reporting against Lawson you could always build a report there as well.
    Joe
    Private
    Private
    Basic Member
    (12 points)
    Basic Member
    Posts:4


    Send Message:

    --
    08/05/2011 12:42 PM
    Hi Tracy, if you haven't found your answer yet, try Article ID:5346234. later...
    TRACY
    Private
    Private
    Veteran Member
    (130 points)
    Veteran Member
    Posts:58


    Send Message:

    --
    08/05/2011 1:19 PM
    Thanks for the help, at least I can get to it this way and then I can pull their names and other stuff in, just seemed to me like Lawson could have made it a little easier since most HR folks want to see the detail behind the numbers.
    You are not authorized to post a reply.