SysCommand Node - Landmark Command

Sort:
You are not authorized to post a reply.
Author
Messages
Maestro
Basic Member
Posts: 10
Basic Member

    I have tried to search for the answer prior to asking this but unfortunately when trying to go past page one of posts i'm getting an error. I'm sure this is relatively simple answer. When using SysCommand node how can i reference a landmark command like dbupdatelobs and wait for it to finish?

     

    Thanks

    Michael 

    David Williams
    Veteran Member
    Posts: 1127
    Veteran Member
      The database commands for Landmark should be executed using the new Landmark Admin node in IPA, not the Sys Command.
      David Williams
      Maestro
      Basic Member
      Posts: 10
      Basic Member

        Thank you very much for the reply. We are on Landmark 10.1.1.66. Unfortunately we don't have that node. we just have the Landmark Transaction node. 

        I was able to finally get sys command to run a landmark trans (listprod) but when I tried to use dbupdatelobs it had a timeout on a reply from the command. More hurdles

        JimY
        Veteran Member
        Posts: 510
        Veteran Member
          Have you tried increasing your Command Timeout value? Not sure what the default is, but it may not be enough for your command to complete. This would be in the System Command tab for what ever configuration set you are using.
          You are not authorized to post a reply.