PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 08/18/2016 11:20 AM by  LauraPat
Second Report to Print Manager
 1 Replies
Sort:
You are not authorized to post a reply.
Author Messages
LauraPat
Sr. Application Engineer
Private
Basic Member
(41 points)
Basic Member
Posts:21


Send Message:

--
08/18/2016 11:16 AM

    I’ve created a custom program that has two reports coming out of it.  I have given the $PRINTFILE command in the .rpt for the second and I open/close the file in the PD and have the workfile defined.  Everything is working and if I go into the Unix print file directory from the command line, I see the second report there but it doesn’t show in the print manager itself.  What am I missing?  I know in Unix (from a script), I can run the loadrpts command to get a file to load to print manager - but this is being created directly within the custom program itself in the .rpt.

     

    Thank you in advance!  I'm going nuts! 

     

    LauraPat
    Sr. Application Engineer
    Private
    Basic Member
    (41 points)
    Basic Member
    Posts:21


    Send Message:

    --
    08/18/2016 11:20 AM
    Never mind - got the answer from another Lawson guru!  If anybody ever has this happen - here's what I needed to do.  I had added the additional print file AFTER I created the original jobdef.   Lawson will only add the GEN table entry for reports on job ADDs, so the print manager didn’t know anything about that new report if you added it after the jobdef was created.  I deleted and re-added the job and the report showed up perfect. 
    You are not authorized to post a reply.