Prev
Next
Forums Lawson Business Intelligence/Reporting/Crystal

Allow Multiple values for a parameter

Sort:
You are not authorized to post a reply.
Author
Messages
Joshua Adams
New Member
Posts: 1
New Member
12/11/2008 7:33 PM
    How do you go about allowing the user to enter multiple values in a parameter? After publishing a Crystal Report to LBI a parameter that is set to "Allow Multiple Values" is rendered as a single text box.

    Is there a seperator that must be used between the multiple values? If so what is this seperator?
    Chris Martin
    Veteran Member
    Posts: 277
    Veteran Member
    12/11/2008 8:59 PM
      use pipes (“|”) as the separator
      Milo Tsukroff
      Veteran Member
      Posts: 47
      Veteran Member
      12/12/2008 5:07 PM
        You can also remove the parameter in LBI.  That forces LBI to send you to Crystal to fill in the parameter. 

        I haven't tested your scenario, but I would think that the original multiple-parameter setup in Crystal will re-appear.  Try it and see!
        John Henley
        Senior Member
        Posts: 3348
        Senior Member
        12/12/2008 5:13 PM
          That is correct.
          Thanks for using the LawsonGuru.com forums!
          John
          You are not authorized to post a reply.