Prev
Next
Forums Human Capital Management Lawson S3 HR/Payroll/Benefits

ACA hours confirmation

 5 Replies
 3 Subscribed to this topic
 68 Subscribed to this forum
Sort:
Author
Messages
BonBon
Advanced Member Send Private Message
Posts: 41
Advanced Member
11/19/2015 5:53 PM
Can anyone share what they are doing to confirm that the hours the BN954 is reporting are the correct hours? Are you comparing the BN954 to anything and what would that be?  I thought I could compare the BN954 to the PR261 in total (by using just the total hours that are in the ACA pay class); however that doesn't exactly work because we sometimes have an item paid in the PR261 that was for a prior pay period adjustment (with a date from the pay period being adjusted).  So I am close; but I have a few more paid hours in my PR261 than the BN954 is pulling (again, probably because of the dates on prior period adjustments).  Thanks for any help!
Bob Canham
Veteran Member Send Private Message
Posts: 217
Veteran Member
11/19/2015 6:07 PM
We dumped hours out of prtime for our ACA pay class and then summarized by process level and employee.
BonBon
Advanced Member Send Private Message
Posts: 41
Advanced Member
11/19/2015 6:22 PM

Thank you for your quick reply.

I thought the ACA was pulling from PRTime.  So that's why I did not try to compare to that.

Bob Canham
Veteran Member Send Private Message
Posts: 217
Veteran Member
11/19/2015 6:34 PM
It does, I was doing the validation to make sure the hours came over as expected and properly aggregated.
BonBon
Advanced Member Send Private Message
Posts: 41
Advanced Member
11/19/2015 6:42 PM
Our HR has not ran in update mode yet in test so I cannot see if the BN hours are populating properly.  I only have the BN954 output from a report mode.
KellyDeMille
New Member Send Private Message
Posts: 1
New Member
11/20/2015 12:10 AM
Has anyone experienced issues importing hours using BN954? I have validated there are hours in PRTime but I get no results when importing (in DEV). I just have company and date range specified without Processing Group, Process Level or employee group. I've also tried selecting a Process Level and/or employee group with the same results. Any insight is appreciated.