LPA scheduled flows

If you are still on PFI (we're on 9.0.1.10) You have to defined the time in two places.
The first under the "First Run Date and Time" - and you must select the time BEFORE you select the date. The second is the "Start Time" where you pull over the desired time from the Available Hours and then adjust the minutes in the box above it.
If those check out okay you might just want to delete the schedule and create it new (there may have been corruption when it was added to the LOGAN table).

No, this is LPA not PFI.

OK, I don't know if those still write to the LOGAN tables? If so, looking at that might provide a clue - what does the recurring_opt field on the logan.wfjobdef table look like for that job_id?

When you scheduled it in IPA, what frequency did you choose? If you used By Day, make sure that after clicking Next, that you choose the Hour to run it under "Year and Specific Time to Run Action". That is what controls the time of day that the flow runs.

Also, you should be able to find your scheduled task and see the next 3 run times under your My Actions in the rich client.

Gary,
That happened to us. We had to set it up in military time separately from the initial run.
use Advanced Schedule Options

FYI we are on

IPA Product Version: 10.0.4.2..5772

Thanks, Bob and Erin. I will make these changes and check it again tomorrow. Will report back.

Yes, looks good - thanks