PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 02/10/2019 7:29 AM by  Jason Beard
Error in LID when doing an LAPM
 2 Replies
Sort:
You are not authorized to post a reply.
Author Messages
SueS
Private
Private
Basic Member
(44 points)
Basic Member
Posts:20


Send Message:

--
02/08/2019 1:43 PM

    Brought over a new custom program from test to prod.  Added the program to security. Compiled the program cleanly.  Tried to do an LAPM to set up the job (LAPM productline PROGNAME).  Filled in the criteria on the various tabs for the form.  When clicking on the add button get the error - "error not found (PROGNAME.101).   We are at a loss as to what is causing this and what to do to resolve it.  Did try deleting it and bringing back over from test to prod again but that did not help.

     

    Tried bringing over another new custom program from test to prod and that one we were able to do the LAPM without issue.

     

    Any insight is appreciated.

    Matt Sherwood
    Private
    Private
    Basic Member
    (44 points)
    Basic Member
    Posts:16


    Send Message:

    --
    02/08/2019 2:01 PM
    It's been awhile for me since I've tried this, but I'm wondering if its unable to find error message 101 in msgmnt for that program?
    Jason Beard
    Private
    Private
    Veteran Member
    (348 points)
    Veteran Member
    Posts:122


    Send Message:

    --
    02/10/2019 7:29 AM
    How did you bring the program over? Obviously copied the source but did you also bring over the metadata? Matt is correct you are missing your error messages. Either migrate the metadata over or msgmnt prod progname and enter the missing messages. There is apparently an issue with some of your data that is causing the program to prevent you from saving the record you just can't see the helpful message as to what is wrong.
    Jason Beard
    617-548-5568
    jabeard3@gmail.com
    You are not authorized to post a reply.